Cisco Router Basic Commands video tutoial – Configure Routing Protocal

Posted on July 8, 2009. Filed under: CCNA | Tags: , , , |


In the section three of CCNA lab video tutorial 3, we will configure the basic routing protocal RIP, so that Router1 and Router2 can communicate with each other.

RIP command for Router0

Dallas>en
Dallas#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Dallas(config)#router rip
Dallas(config-router)#?
auto-summary         Enter Address Family command mode
default-information  Control distribution of default information
distance             Define an administrative distance
exit                 Exit from routing protocol configuration mode
network              Enable routing on an IP network
no                   Negate a command or set its defaults
passive-interface    Suppress routing updates on an interface
redistribute         Redistribute information from another routing protocol
timers               Adjust routing timers
version              Set routing protocol version
Dallas(config-router)#network 10.0.0.0
Dallas(config-router)#network 11.0.0.0
Dallas(config-router)#

RIP command for Router1

Miami>en
Miami#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Miami(config)#router rip
Miami(config-router)#network 11.0.0.0
Miami(config-router)#

RIP command for Router2

SanFrancisco>en
SanFrancisco#config t
Enter configuration commands, one per line.  End with CNTL/Z.
SanFrancisco(config)#router rip
SanFrancisco(config-router)#network 10.0.0.0
SanFrancisco(config-router)#^Z
%SYS-5-CONFIG_I: Configured from console by console
SanFrancisco#show ip route
Codes: C – connected, S – static, I – IGRP, R – RIP, M – mobile, B – BGP
D – EIGRP, EX – EIGRP external, O – OSPF, IA – OSPF inter area
N1 – OSPF NSSA external type 1, N2 – OSPF NSSA external type 2
E1 – OSPF external type 1, E2 – OSPF external type 2, E – EGP
i – IS-IS, L1 – IS-IS level-1, L2 – IS-IS level-2, ia – IS-IS inter area
* – candidate default, U – per-user static route, o – ODR
P – periodic downloaded static route

Gateway of last resort is not set

C    10.0.0.0/8 is directly connected, FastEthernet0/0
R    11.0.0.0/8 [120/1] via 10.0.0.2, 00:00:10, FastEthernet0/0
SanFrancisco#ping 11.0.0.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 11.0.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 47/59/63 ms

SanFrancisco#

Advertisements

Make a Comment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

2 Responses to “Cisco Router Basic Commands video tutoial – Configure Routing Protocal”

RSS Feed for IT Certifications Comments RSS Feed


Where's The Comment Form?

Liked it here?
Why not try sites on the blogroll...

%d bloggers like this: